Opel Corsa: General Information / Vehicle storage. End-of-life vehicle recovery
Vehicle storage
Storage for a long period of time
If the vehicle is to be stored for several
months:
- Wash and wax the vehicle.
- Have the wax in the engine
compartment and underbody
checked.
- Clean and preserve the rubber
seals.
- Fill up fuel tank completely.
- Change the engine oil.
- Drain the washer fluid reservoir.
- Check the coolant antifreeze and
corrosion protection.
- Adjust tyre pressure to the value
specified for full load.
- Park the vehicle in a dry, well
ventilated place. Engage first or
reverse gear or set selector lever
to P. Prevent the vehicle from
rolling.
- Do not apply the parking brake.
- Open the bonnet, close all doors
and lock the vehicle.
- Disconnect the clamp from the
negative terminal of the vehicle
battery. Note that all systems are
not functional, e.g. anti-theft
alarm system.
Putting back into operation
When the vehicle is to be put back into
operation:
- Connect the clamp to the
negative terminal of the vehicle
battery. Initialise the power
windows.
- Check tyre pressure.
- Fill up the washer fluid reservoir.
- Check the engine oil level.
- Check the coolant level.
- Fit the number plate if necessary.
End-of-life vehicle recovery
Information on end-of-life vehicle
recovery centres and the recycling of
end-of-life vehicles is available on our
website, where legally required. Only
entrust this work to an authorised
recycling centre.
We recommend the use of genuine
parts and accessories and factory
approved parts specific for your
vehicle type. We cannot assess or
guarantee reliability of other products
- even if they have a regulatory or
otherwise granted approval...
Other information:
Activation
When exiting a parallel parking slot,
activate the system in the Info Display.
Select the exiting a parallel parking
slot menu.
Select exit side by switching on the
respective turn light.
Engage reverse or forward gear,
release the steering wheel and start
moving without exceeding 5 km/h.
Move forwards and backwards while
observing the warnings of the parking
assist until the en..
LED tail lights
Have lights repaired by a workshop in
case of failure.
Light assembly in the body
Open the tailgate then remove the
access cover on the relevant side.
Slacken the lamp fixing nut using
a box spanner or socket.To avoid losing the nut if it drops
into the wing trim, first place a
cloth below it.
Manually unscrew and remove
the lamp fixing nut.
Carefully withdraw ..